running unloaders - for continuous running air compressors, unloader
lets unit idle load-free until air supply drops to cut-in pressure;
automatically lets unit unit idle again after high pressure limit
||Cast iron high
tensile strength rods - with
replaceable rod bearings and pin
bushings. Machined to close tolerances for many years of services.
Oil entrance ports are machined at the crankshaft journal and at the
piston pin to allow the flow of fresh oil throughout the rod.
stainless steel valves - standard on all CA Series compressors. Lapped
to optical flatness for high extended wear.
iron crankshaft - dynamically balanced, precision-machined, and
ground. Assures extended running life for all internal bearing and
||Large intake filter
silencers - for quiet operation.
||Cast iron crankcase- for
strength and durability.
||Deep finned cylinders and
heads - for cool operation.
||Balanced flywheel - for
smooth operation with high volume airflow to cool heads and cylinders.
iron cylinders - precision bored for high performance and
low oil carry-over.
main roller bearing - precision fit to hold
alignment of all rotating parts.
- long-life industrial design compression and oil control rings for
sightglass - conveniently located for reading of oil level in crank